September 19, 2021

BMW ABS/DSC Warning Light Reset via Foxwell NT680 Pro

The BMW 3 series has an ABS and traction warning light on the dashboard, so I’m gonna show how to reset it with the Foxwell NT680 Pro Scan Tool.

Plug connector into OBD2 port, press
Diagnostic >> Europe >> BMW >> Manual selection >> 3 series >> F30/F31/F35
bmw-abs-dsc-warning-light-reset-via-foxwell-nt680-pro (1)

bmw-abs-dsc-warning-light-reset-via-foxwell-nt680-pro (2)

bmw-abs-dsc-warning-light-reset-via-foxwell-nt680-pro (3)

bmw-abs-dsc-warning-light-reset-via-foxwell-nt680-pro (4)

Turn off the ignition.
Wait for approx 10s…
Switch on the ignition again.

Diagnosis >> Control modules >> Chassis >> ABS-DSC dynamic stability control >> Read codes

It tells about one fault code:
48082A – Wheel speed sensor: voltage supply, short circuit to B+. rear right.

The information means the rear right ABS sensor or wheel speed sensor is actually faulty, which needs to be replaced.
bmw-abs-dsc-warning-light-reset-via-foxwell-nt680-pro (5)

bmw-abs-dsc-warning-light-reset-via-foxwell-nt680-pro (6)

bmw-abs-dsc-warning-light-reset-via-foxwell-nt680-pro (7)

Having been replaced with a new sensor, let’s go back to
Clear codes >> Codes cleared, OK

Now you can see, the warning lights on the dashboard have gone!
BMW ABS/DSC warning light reset is successful.
bmw-abs-dsc-warning-light-reset-via-foxwell-nt680-pro (8)

bmw-abs-dsc-warning-light-reset-via-foxwell-nt680-pro (9)

This is using Foxwell NT680 Pro Scanner to get rid of the warning lights for a BMW. It also supports the most 21 frequently performed services like DPF, EPB, SAS, BRT, gearing learning…etc.
Specific functions supported car list welcome to contact service online.

https://www.foxwellstore.com/