As one of the outstanding representative Foxwell Automotive Service Tools currently, Foxwell NT630 Plus OBD2 scanner has got highly praised from the customers, because it enables mechanics, the staff of repair shops and car DIYers to do an accurate and professional diagnosis of ABS/SRS/SAS faults, and remove air from the internal brake fluid chambers after servicing the brakes. Moreover, it is an ABS bleeding scan tool that you can use this diagnostic scanner to help bleed the brake, cycling the pump and valves during the bleeding process. Moreover, benefiting from perfect compatibility, it is compatible with almost all OBDII cars, SUVs, minivans, light-duty trucks sold worldwide, which makes it suitable for both mechanic and DIYers.
In the following content, let’s see the FAQs about this device and try to know more about the practical needs or problems that customers care most about.
Q1: Will NT630 Plus reset the airbag light on a 2014 RAM 2500?
A1: YES, this OBD2 scanner will support your vehicle.
Q2: Is it possible to use NT630 Plus to perform Auto ABS brake bleeding?
A2: Concerning this special function, this tool is not a universal all-car-model auto bleed tool. You can see the customer’s experience of doing brake bleeding below for a reference.
“I tested in my 2012 Ford edge – NO auto bleed but I could run the specific ABS components like the pump – which did fix my soft pedal. I tested in my 2003 and my 98 Ford E350 – that did do Auto Bleed – tested in 2011 Honda CRV and I could not find any ABS pump functions but I was able to clear some evap codes that my previous code reader could not do. so its a case by case basis. I think it has to do with each car companies internal capabilities in ECM
The ABS can get stuck in a mode that cycles fluid in a loop – I ended up replacing the HCU part of the ABS with the used unit and you still will have some trapped air – so you need to activate the ABS pump at minimum to get the air out of it. and valves to cycle. I got my Edge back to good pedal again. after I replaced master cyl – and ABS module and manual bleed – could drive but soft-pedal – then send to a chain garage for a brake fluid flush – no better. Then I used Foxwell NT630 Plus now fixed it successfully!”
Q3: Will NT630 Plus remove airbag light on 2008 Hyundai Tiburon?
A3: This scanner supports removing the airbag light on the 2008 Hyundai Tiburon, except for the airbag fault that due to the collision of the vehicle.
Q4: Can NT630 Plus read and clear SRS codes (not just the airbags but seat belt codes, etc) on 2004 CRV Hondas?
A4: Yes, this scanner will support your vehicle. (Note: It will not clear the airbag crash data)
Q5: Can this NT630 Plus tool support reset and /or calibrate SAS in the 2009 Subaru Forester?
A5: Yes, it will work well with your vehicle.
Q6: Will NT630 Plus scanner support features like transmission, transfer case, differentials, water pump-thermostat, ABS, airbag, etc work well for BWM X3 (e83)? Is there any limitation for This car model?
A6: Your car model selection is in the car list of this tool, but I did not find any real helpful info on the transfer case, transmission, and differentials, and sensors are shown to be either working or not. So these functions may not be supported. ABS, airbag, fuel delivery, code reading all worked fine for your car.
Q7: Can Foxwell NT630 Plus reset and show ABS and ESC data and codes on a 2009 Kia Optima?
A7: We are very sorry that the Foxwell NT630 Plus OBD2 scanner does not support your vehicle to read ESC data, but it will read ABS data for your vehicle.
Q8: Will this NT630 Plus unit help me diagnose an airbag light and tell me what part of my 2016 Nissan Xterra breaks down?
A8: Yes, it can diagnose SRS on the 2015 Nissan Xterra, you can get the fault code to read which part actually has broken down and had it repaired, then get back to diagnose again and erase the corresponding fault code.
Q9: Is it possible to use this NT630 plus scanner to find the VIN number automatically?
A9: Well, for the majority of the car models in its car list, it can find the VIN automatically. It will work perfectly. But if it happens to fail for some car models in very few cases, you can contact us and provide the car model, we will check the VIN for you.
Q10: Will this NT630 Plus help me read ABS codes and determine which wheel sensor is malfunctioning?
A10: Yes, Foxwell NT630 Plus OBD2 Scanner will support read ABS codes and tell you what exact part of your car’s wheel sensor doesn’t work. But not all functions are compatible with all vehicles for this scanner. So you need to check the car list.
To be continued…
For more product information and its service, please check the website of foxwellstore.com.